What This Guide Covers
If you're servicing the fuel system on your 2018-2023 Honda Accord 1.5T, the fuel feed hose that runs from the firewall to the fuel rail is a specific factory part that may need replacement. This guide explains what the Genuine Honda Fuel Feed Hose does, which models it fits, and the key steps involved in replacing it.
Part Information at a Glance
- Genuine Honda 2018-2023 Accord 1.5T Fuel Feed Hose: Genuine Honda 2018-2023 Accord 1.5T Fuel Feed Hose, Honda Part Number 16722-6A0-A01 This is the factory replacement fuel feed hose, designed specifically for the firewall-to-fuel-rail connection on all 2018-2023 Accord 1.5T variants, including RHD and international models.

Genuine Honda 2018-2023 Accord 1.5T Fuel Feed Hose
Replacement Steps
The following steps are based on general fuel line replacement practice. The supplied catalog does not include detailed installation instructions, so always refer to a factory service manual for torque specs and specific procedures.
- Depressurize the fuel system: Relieve fuel pressure by removing the fuel pump fuse and running the engine until it stalls, or follow the procedure in your service manual. Disconnect the battery negative terminal.
- Locate the fuel feed hose: The hose runs from the firewall connection to the fuel rail on the engine. It is held in place by retaining clips at each end.
- Remove the old hose: Carefully release the retaining clips using the appropriate tool. Slide the hose off the fuel rail and firewall fittings. Inspect the fittings for damage.
- Install the new hose: Push the new Genuine Honda fuel feed hose onto both fittings until fully seated. Secure with the retaining clips. Ensure the hose is routed away from hot or moving components.
- Reconnect and test: Reconnect the battery, reinstall the fuel pump fuse, and turn the ignition to ON (without starting) to pressurize the system. Check for leaks at both connections. Start the engine and verify no fuel odor or drips.
Compatibility Note
The Genuine Honda Fuel Feed Hose (part 16722-6A0-A01) is confirmed to fit all 2018-2023 Accord 1.5T variants, including RHD and international models. It is a direct factory replacement, so no modifications are needed.
What the Catalog Does Not Confirm
The supplied catalog does not include specific torque values, clip removal tools, or detailed routing diagrams for this replacement. For complete instructions, consult a Honda service manual or a qualified technician. The hose itself is a standard factory part with no special installation requirements beyond proper seating and clip engagement.


