How to Install a Genuine Acura TPMS Sensor

By PRL Motorsports - Premium Automotive Performance Products | Published: 2026-10-25

Category: How-to Guides

Learn how to install a genuine Acura TPMS sensor on your Integra or TLX. Step-by-step guide with common mistakes and checkpoints.

Quick answer

Install a genuine Acura TPMS sensor by mounting it to the wheel, torquing the valve stem to spec, and re-learning the sensor with the vehicle's TPMS tool or the recommended relearn procedure.

Why use a genuine Acura TPMS sensor?

A genuine Acura TPMS sensor is designed to match the factory frequency and programming of your vehicle, so it communicates correctly with the TPMS display. This avoids the common issue of aftermarket sensors that either fail to pair or show inaccurate readings. It also includes the complete housing, which makes installation straightforward and reliable.

Important considerations before you start

The genuine Acura TPMS sensor fits all 2023+ Acura Integra and 2021+ Acura TLX models, including RHD and international variants. It can also be used with aftermarket wheels, but you need to ensure the wheel has a compatible valve stem hole. If you are mounting new tires, the sensor is installed before the tire is fully mounted on the rim. If you are replacing a sensor on an existing wheel, the tire must be dismounted to access the sensor.

Installation steps

Prepare the wheel: If the tire is still mounted, dismount it using a tire machine. Clean the valve stem hole area on the rim to ensure a proper seal. Check the rim for any corrosion or debris that could prevent a good seal.
Mount the sensor: Insert the genuine Acura TPMS sensor through the valve stem hole from the inside of the wheel. Align the sensor so it sits flush against the rim, then hand-tighten the retaining nut. Use a torque wrench to tighten the nut to the manufacturer's specification (typically around 4-6 Nm, but confirm with your vehicle's service manual). Over-tightening can crack the sensor housing or strip the threads.
Mount the tire: Carefully mount the tire back onto the wheel, making sure not to pinch the sensor or its wiring. Inflate the tire to the recommended pressure. Use a tire machine with a plastic or rubber pad to avoid damaging the sensor.
Re-learn the sensor: Use the TPMS relearn procedure for your vehicle. This usually involves using a TPMS scan tool or following the vehicle's menu to enter relearn mode, then activating each sensor by holding a magnet or the tool near the valve stem. The horn or lights will confirm each sensor is learned. If the sensor doesn't respond, check the sensor battery and ensure it is the correct frequency for your vehicle.
Verify operation: After relearning, drive the vehicle at speeds above 15 mph for a few minutes. The TPMS warning light should turn off, and the display should show the correct tire pressures. If the light remains on, re-check the sensor installation and relearn procedure.

Product facts

Genuine Acura Tire Pressure Monitor Sensor (TPMS): This genuine Acura TPMS sensor fits all 2023+ Acura Integra and 2021+ Acura TLX models, including RHD and international variants. You can be confident the sensor will work with your specific vehicle without compatibility issues.
Genuine Acura Tire Pressure Monitor Sensor (TPMS)